| # ---------------------------------------------------------------------------- | |
| # ATMEL Microcontroller Software Support | |
| # ---------------------------------------------------------------------------- | |
| # Copyright (c) 2008, Atmel Corporation | |
| # | |
| # All rights reserved. | |
| # | |
| # Redistribution and use in source and binary forms, with or without | |
| # modification, are permitted provided that the following conditions are met: | |
| # | |
| # - Redistributions of source code must retain the above copyright notice, | |
| # this list of conditions and the disclaimer below. | |
| # | |
| # Atmel's name may not be used to endorse or promote products derived from | |
| # this software without specific prior written permission. | |
| # | |
| # DISCLAIMER: THIS SOFTWARE IS PROVIDED BY ATMEL "AS IS" AND ANY EXPRESS OR | |
| # IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF | |
| # MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT ARE | |
| # DISCLAIMED. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, | |
| # INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT | |
| # LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, | |
| # OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF | |
| # LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING | |
| # NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, | |
| # EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. | |
| # ---------------------------------------------------------------------------- | |
| #******************************************************* | |
| # | |
| # Connect to J-Link and debug application in flash. | |
| # | |
| # define 'reset' command | |
| define reset | |
| # Connect to the J-Link gdb server | |
| target remote localhost:2331 | |
| # Reset the chip to get to a known state | |
| monitor reset | |
| # Select flash device | |
| monitor flash device = AT91SAM3X8H | |
| # Enable flash download and flash breakpoints | |
| monitor flash download = 1 | |
| # Load the program | |
| load | |
| # Reset peripheral (RSTC_CR) | |
| set *0x400e1a00 = 0xA5000004 | |
| # Initializing PC and stack pointer | |
| # Modify pc value to even before writing pc register | |
| mon reg sp=(0x80000) | |
| set *0x80004 = *0x80004 & 0xFFFFFFFE | |
| mon reg pc=(0x80004) | |
| info reg | |
| # end of 'reset' command | |
| end |